What problems will the cable tray encounter in use?

電纜橋架廠家作為一種智能化弱電體系，在咱們往常的生活中發揮著重要的作用。但是其往常也會呈現毛病，給我們生活形成困惑。那我們知道電纜橋架都會呈現哪些毛病嗎?

As an intelligent weak current system, cable tray manufacturers play an important role in our usual life. But it will also present problems as usual, which puzzles our life. Do we know what problems will appear in the cable tray?

一、可能呈現的毛病：電纜的各部分都呈現短路表象，這類毛病可能會形成配電柜上的電流繼電器作業，對電纜形成的損壞十分嚴峻;

1、 Possible faults: all parts of the cable show the appearance of short circuit, which may cause the operation of current relay on the distribution cabinet, and the damage to the cable is very serious;

二、會呈現的毛?。弘娎|內部呈現短路，這類毛病通常是因為電纜質量低質而形成的，外表上不會流露痕跡;

2、 Problems that will appear: there is a short circuit inside the cable, which is usually formed due to the low quality of the cable, and there will be no trace on the surface;

三、可能會呈現整條電纜被燒斷或許某處電纜被燒斷，使得電纜在毛病處損壞的十分嚴峻;

3、 It may appear that the whole cable is burnt out, or the cable is burnt out somewhere, which makes the cable seriously damaged at the fault;

四、可能會呈現的毛病為電纜橋架只有一條短路，毛病處電纜損壞較輕，但還是會有很明顯的痕跡。

4、 The possible fault is that there is only one short circuit in the cable tray. The cable damage at the fault is light, but there will still be obvious traces.

這類毛病可能會呈現的原因在于電流太大或許電纜質量太差而形成的。

The reason why such problems may appear is that the current is too large or the cable quality is too poor.

所有的機械設備使用后都要定期進行檢查、保養，電纜橋架廠家就來談談如何對電纜橋架設備進行檢修、保養。

All mechanical equipment should be inspected and maintained regularly after use. The cable tray manufacturer will talk about how to overhaul and maintain the cable tray equipment.

1、電纜橋架設備平衡氣缸動作狀況及其機油潤滑系統油路,接頭等測試檢查.

1. Test and check the action condition of balance cylinder of cable tray equipment and its oil circuit and joint of oil lubrication system

2、電纜橋架設備滑塊與導軌之間的摩擦較為頻繁，應做必要的調整較正，檢查接頭部位的潤滑管路等，保證良好的運轉。

2. The friction between the sliding block of cable tray equipment and the guide rail is relatively frequent, so necessary adjustment and correction shall be made, and the lubrication pipeline at the joint shall be checked to ensure good operation.

3、定期為電纜橋架設備齒輪部位潤滑：齒輪傳動箱及內部機件因為經常運轉損壞的可能性比較大，出現松動的可能性更大。

3. Regularly lubricate the gear parts of cable tray equipment: the gear box and internal parts are more likely to be damaged due to frequent operation, and there is a greater possibility of looseness.